Do I need to drill new fog light cutouts to fit this bumper?

This bumper features the RBS V1 design profile. Compare the fog hole locations on this piece to your OEM bumper cutouts before final installation. If your existing fog light bezels align with this design, you're set. If not, you'll need to map out the new hole locations and cut accordingly.

Will this bumper work with my factory parking sensors?

The RBS V1 design may or may not include sensor cutouts depending on your specific bumper configuration. Verify your OEM sensor locations and compare them to this bumper's lower panel before committing to installation. If the sensor holes don't align, you can drill new ones to match your vehicle's sensor placement.

What prep and paint should I use before installing?

Sand the bumper surface with appropriate grit to establish a clean substrate, then apply your chosen primer and paint system. FRP responds well to standard automotive primers and topcoats. Since this ships raw FRP, you have flexibility with your finish approach — epoxy, urethane, or acrylic systems all work well on FRP.