Will this fit the existing sensor holes in my bumper?

This bumper ships without pre-drilled sensor cutouts. Before installation, reference your vehicle's OEM bumper hole locations and mark them on the new panel. You can then drill or route sensor holes to match your setup. Test-fit the bumper first to confirm alignment before finishing.

Can I prep and paint this bumper before bolting it on?

Yes. In fact, off-vehicle prep is common practice. Sand and prep the surface according to your chosen paint system, apply primer and color coat, then install once dry. This gives you better access for masking and prevents overspray on your vehicle's body.

Does the parking sensor or fog light cutout position match my factory bumper?

Measure and confirm the cutout locations on your existing bumper before committing. RBS V1 styling may position these elements differently than OEM. Mark your drilling points carefully and test-fit the bumper dry on the vehicle to verify clearance and alignment with any sensors, lights, or accessories.