8 gpm 3500 psi Skid Mounted Pressure Washer Gun Wand Hose Battery Box

8 gpm 3500 psi Honda GX690 24 hp General Pump TSF2021 V-belt special powder coated steel frame, commercial lock up, pressure trapped unloader, 5 quick connect colored nozzles

Standard features

Lifetime frame warranty

Easy access single bolt interlocking belt cover

Single bolt engine adjustable belt tension

E-start valve

Adjustable pressure unloader but is set at 3700 psi and meant to be left alone and never adjusted

26 Amp charging system

We highly recommend adding the best high pressure 3/8" ball valve (6292.SM) to this order to allow 

Engine and pump oil drains offer easy maintenance

Dual padded shock absorbing feet

3VX425 belt system offers balanced power transfer

Commercial/industrial grade engines

Low speed pump and thermo-sensor (prevents overheating in bypass mode)

Can not be shipped inside the state of California 

Note: All units are completely factory assembled, tested in the USA, and delivered ready to operate. Must provide battery.

You need 4 x 2.5 orifice 25 degree nozzles for a four tip bar (2812) or 2 x 4.5 orifice 25 degree nozzles for a two tip bar (1122).

We carry everything you need to plumb this pressure washer in a kit which is part number, PL-8-TA for a horizontal leg tank or PL-8-TO for an IBC tote (as pictured). This kit has everything but the water and liquid Teflon!

As with any pressure washer, do not adjust the unloader. The unloader is set at a spike pressure of 200 psi above the operating pressure of the pump and meant to be left alone. If you need less pressure, change out the nozzles to a larger orifice and never smaller than what is called for using factory specifications using gpm and pressure. This unit requires a 8.5 orifice or larger. you can add a 6540-8 JROD kit to play with nozzle distances and pressures.

Always install your chemical injector at least 2-3 feet downstream from your unloader to prevent back-siphoning of chemicals into the wetted internal components of your unloader. Always remove your chemical injector when not in use. Inspect the orifice inside the chemical injector and notice the restriction it causes in flow and pressure. When using your surface cleaner, you need as much flow and pressure as possible. 

Install a high temperature Hudson float valve (Hudson-HT) using everything you need to install it into your water tank with our Hudson assembly (Hudson-A or HB). The Hudson Assembly installs into the very top of the tank using a bulkhead and garden hose connection to prevent the tank from over-flowing.

SKU: PW.8G3546